Global Tractor Alternator Market 2023-2028

    In Stock

    GLOBAL TRACTOR ALTERNATOR MARKET

     

    INTRODUCTION

    Modern automobiles are jam-packed with electric and electronic components, with the alternator being one of the most important. While the car is operating, it supplies electricity to the rest of the electrical system.

     

    The alternator, which is usually mounted to the side or top of the engine and is powered by a belt, is primarily made up of two windings of wire.

     

    When current is applied to the inner coil (rotor), magnetism is produced; when this is spun within the outer coil of wire (stator), a flow of electrical current is produced.

     

    Most agricultural or road vehicles utilize a 12V system; bigger commercial vehicles may use a 24V system. A battery functions as an energy storage tank. It can only provide electricity for so long before it fails.

     

    infographic: Tractor Alternator Market, Tractor Alternator Market size, Tractor Alternator Market trends , Tractor Alternator Market forecast, Tractor Alternator Market risks, Tractor Alternator Market report

     

    The power generated by the alternator at first is in the form of alternating current (AC), which consists of electrical pulses that change direction periodically. Because this alternating current is unsuitable for battery charging, a rectifier transforms the power produced to direct current (DC).

     

    Using diodes, the rectifier soothes out the ‘pulses.’ These are tiny electrical components that act as ‘one-way valves’ to convert AC to DC. The rectifier is often connected to the alternator; however it may be installed outside on older cars or smaller machines (with lesser electrical output) such as ATVs.

     

    Following that, the regulator is responsible for keeping the voltage inside the electrical system under control. A completely charged battery will normally have a voltage of slightly more than 12.6V, but it will require 13.8-14.4V to recharge.

     

    The regulator device initially draws electricity from the battery via the key switch and dash charging light and feeds it into the rotor via the slip rings.

     

    GLOBAL TRACTOR ALTERNATOR MARKET DYNAMICS

    The Previous decades of Industrialization had noticed a 5 Stage development phase for agricultural modernization within the country wide perspective.

     

    The Tractors had moved into action during the Construction stage of modernized agricultural machinery with Tractors being put upon as key important requirements in the country.

     

    It was important for China to have a considerable amount of investment to fight the production rates with the developed countries.

     

    North America is the second fastest growing starting motor and alternator industry, with rigorous pollution standards pushing the development of advanced technology.

     

    The government has implemented stringent fuel pollution and fuel economy standards across the world. This has resulted in an increase in the use of electrical and electronic components on a wide scale in automobiles during the last decade.

     

    Engine downsizing has prompted manufacturers to create starter motors and alternators that are compatible with the new trend. Various technologies have been implemented, including upgraded starters, integrated starting generators, and direct start. These technologies are finding applications.

     

    The rising involvement of electrical and electronic components in vehicles, which needs more power, is one of the key drivers for the automotive starting motor and alternator market.

     

    Another element directly driving demand for starter motor and alternator is increasing vehicle production. However, rising demand for electric cars has been a significant impediment to the market’s expansion.

     

    GLOBAL TRACTOR ALTERNATOR MARKET SEGMENTATION

     

    The Global Tractor Alternator Market can be segmented into following categories for further analysis.

     

    By Output Horsepower

    • Less than 40 HP
    • 40 HP – 99 HP
    • 100 HP – 149 HP
    • 150 HP – 199 HP
    • 200 HP – 249 HP
    • 249 HP – 300 HP
    • 301 HP – 350 HP
    • Greater than 351 HP

     

    By Speed Classification

    • Low Speed Alternators
    • Medium Speed Alternators
    • High Speed Alternators
    • Ultra-High-Speed Alternators

     

    By Movement Application Type

    • Pneumatic Based Tractors
    • Track / Crawler Based Tractors
    • Chain Type Tractors

     

    By Regional Classification

    • Asia Pacific Region – APAC
    • Middle East and Gulf Region
    • Africa Region
    • North America Region
    • Europe Region
    • Latin America and Caribbean Region

     

    RECENT  TECHNOLOGICAL TRENDS IN GLOBAL TRACTOR ALTERNATOR MARKET

     

    SI No Timeline Company Developments
    1 Q4-2021 FAW FAW Tractor and Truck spare parts designed alternator model 612630060039 featured with claw pole type brushless alternator, electromagnetic vibratory voltage adjusting and also with front head cover position.
    2 Q4-2021 WMM WMM alternator model 3116676R91 12V low rpm alternator for Messey Ferguson tractor models 50D, 50E, 50EX, 50H, 50HX and 60H.
    3 Q4-2021 Nippon Denso Nippon Denso alternator model 021000-8660 featured a 12V 35A permanent magnet type brushless alternator for Kubota tractors.
    4 Q4-2021 AJ Electric AJ Electric introduced its 24V 40A delco universal replacement alternator 4024wdp with double pulley for both tractor and industrial applications.
    5 Q4-2021 Delco Delco produced its new alternator Delco 10SI comes with a 24V 40A single wire system, with spool mounting type and external fan location fits for John Deere tractor models.
    6 Q3-2021 Dongfeng Motor Corporation Agriculture machinery equipment and automobile manufacturer Dongfeng Motor Corporation revealed the brushless automotive alternator JFWB17A comes with aluminum alloy body material.
    7 Q3-2021 Parts Player Parts Player new alternator for Messey Ferguson and New Holland tractors models comes with 12V 55A with model name Luca IR/EF.
    8 Q2-2021 Rareelectrical Rareelectrical launched a new 12V 35A alternator for John Deere tractor models with improved efficiency, and the alternator model is MAZA096672.

     

    The Tractors in China have implemented the Position Control System wherein the position of a fully mounted implement sprayer or fertilizer distributor is automatically maintained in a constant position (e.g. operating height over the ground) despite leakages in the hydraulic system tending to lower the position of the implement.

     

    Other mechanizations include sophisticated hydraulic systems are now available on all modern tractors capable of performing additional functions including the operation and control of a multiplicity of implements and machines mounted to the rear, front or side of the tractor including loaders, mowers, agrochemical applicators, harvesters, and feeders.

     

    Infographic: Global Tractor Alternator Market, Global Tractor Alternator Market Size, Global Tractor Alternator Market Trends,  Global Tractor Alternator Market Forecast,  Global Tractor Alternator Market Risks, Global Tractor Alternator Market Report, Global Tractor Alternator Market Share

     

    In terms of increasing the agricultural efficiency and time conservation perspective , Automation robots have been brought into existence and extensive trials within China.

     

    China has been working on the development of precision autonomous machinery. Much work has been carried out in several areas. These include tractor guidance, whether it is laser-based or GPS-based.

     

    For agricultural tasks, precision guidance of the tractor is necessary, but not sufficient, as the tasks themselves are generally carried out by some form of trailing implement which brought upon the integration of Tractor Implement precision.

     

    In its original configuration, the tractor alternator has a six-pole permanent magnet rotor. The rotor is surrounded by three separate stators (stacks of laminated steel plates), each having 100 turns of wire (phase winding).

     

    Because of mechanical construction restrictions, the air gap was somewhat larger than the design value, and the measured leakage inductance at nominal speed and load was 154 mH, which was more than planned.

     

    The terminal voltage for a particular load was estimated using these parameters. When tested for the same load, the terminal voltage was lower. This was determined to be the result of armature response.

     

    COMPETITION LANDSCAPE

    There were several approaches to establish electric  drives in  agricultural machines. The increased global population necessitates a greater need for agricultural equipment. With present technology, agricultural equipment has reached its optimal limitations in terms of complexity and efficiency.

     

    Furthermore, advancements in drive technology, which is now dominated by mechanical or hydraulic drives, are limited. As a result, in the future, the emphasis in this area will be on electrical drives. Agricultural vehicles now use 14V power solely for on-board use. A high voltage system was fitted to an agricultural vehicle, the John Deere E Premium tractor, during the 2007 Agrotechnical Fair.

     

    Spark Minda has been developing new technologies of Alternators within the market, which are focused on new based developments and requirements of efficiencies.

     

    The Alternators are currently produced using the most recent technology known as Gear-Reduction Technology. These GRS technology Starter motors are rapidly replacing Direct-Drive technology Starter motors in a variety of applications.

     

    When compared to the Direct-Drive design, GRS Starter motors are lighter and smaller in size. This technology provides high specific torque and starting speed, as well as efficient and speedier engine start ability, making it an excellent choice.

     

    Alternators are built based on the current Conventional designs with External Fan and Internal Fan types. These are classical and ventilated versions, that are used in various segments like Tractors, Farming equipment and Stationary engines.

     

    These Alternators are built with utmost care for ensuring stability of Output for continuous charging to battery, while operating under different working environments and applications.

     

    MeccAlte is also one of the leading alternator technology developers for the tractors in the global scale of production market. Mecc Alte manufactures a comprehensive range of agricultural alternators and PTO generators; dependability is at the core of all we do and the emphasis of everything we make.

     

    It can supply either base alternators or entire Power Take Off (PTO generator) tractor drive units for most systems. PTO generators are tractor-driven power units that contain an alternator with control box, overgear with shaft guard, and a three-point linkage support frame. These Power Take Off devices are intended to offer dependable backup power in the case of a power outage.

     

    PTO generators are built with a strong frame that links via a three-point linkage and are powered by a tractor’s power take-off. Our agricultural alternators and PTO generators provide a remarkable starting capacity for electric motors, guaranteeing they meet the roughest demands when power is most needed. They are distinguished by proven high-performance levels and durable construction, with maximum dependability.

     

    Mecc Alte is delighted to be the largest independent maker of Farm alternators, with the greatest assortment of any Agricultural alternator manufacturer, as an inventive and active firm. This variation is Mecc Alte’s biggest strength in providing an alternator that is versatile.

     

    COMPANIES PROFILED

    • Crown Equipment Corporation
    • Doosan Corporation
    • Godrej Material Handling
    • Hyster-Yale Group, Inc.
    • Jungheinrich AG
    • Kion Group
    • Linde Material Handling
    • Mitsubishi Caterpillar Forklift America Inc.
    • The Raymond Corporation
    • Toyota Industries Corporation
    • Uvundlu Investments Holdings (Pty) Ltd
    • Hyundai Heavy Industries Co. Ltd.
    • KION GROUP AG
    • Noveltek Industrial Manufacturing Inc.
    • Presto Lifts Inc.
    • Spark Minda Inc.
    Sl no Topic
    1 Market Segmentation
    2 Scope of the report
    3 Abbreviations
    4 Research Methodology
    5 Executive Summary
    6 Introduction
    7 Insights from Industry stakeholders
    8 Cost breakdown of Product by sub-components and average profit margin
    9 Disruptive innovation in the Industry
    10 Technology trends in the Industry
    11 Consumer trends in the industry
    12 Recent Production Milestones
    13 Component Manufacturing in US, EU and China
    14 COVID-19 impact on overall market
    15 COVID-19 impact on Production of components
    16 COVID-19 impact on Point of sale
    17 Market Segmentation, Dynamics and Forecast by Geography, 2023-2028
    18 Market Segmentation, Dynamics and Forecast by Product Type, 2023-2028
    19 Market Segmentation, Dynamics and Forecast by Application, 2023-2028
    20 Market Segmentation, Dynamics and Forecast by End use, 2023-2028
    21 Product installation rate by OEM, 2023
    22 Incline/Decline in Average B-2-B selling price in past 5 years
    23 Competition from substitute products
    24 Gross margin and average profitability of suppliers
    25 New product development in past 12 months
    26 M&A in past 12 months
    27 Growth strategy of leading players
    28 Market share of vendors, 2023
    29 Company Profiles
    30 Unmet needs and opportunity for new suppliers
    31 Conclusion
    32 Appendix
     
    0
      0
      Your Cart
      Your cart is emptyReturn to Shop